Dziwne,że kraj producenta tego nie podaje,zwykle są charakterystyki podawane.
Z technologii budowy też coś wynika.Podobno nie są prętowe,więc raczej do 200 MHz góra powinny
może jeszcze sięgać,ale nie są koncentryczne,więc raczej radaru lub sieci komórkowej
mogą nie obsłużyć.Mają odpowiedniki zachodnie,zwłaszcza-amerykańskie.
Trzeba po parametrach popatrzeć.
Tyle tak ogólnie i "od ręki" ,bo jestem na wyjeździe.
Na pewno np. Kolega OTLamp będzie coś więcej wiedział.
Jacek"b/t"
PS:na str.angielskiej piszą tak:
The 6 series are just miniature versions of USA B5A, B7G and B9G mains valves. They are not battery "Rod" Pentodes, nor even particularly Russian other than manufacture..
Vf 6.3 Volts / If 0.2 Ampere / Indirect / Parallel / series AC/DC /
Some are Russian "button base" (i.e like DM70 wired) copies of the USA B5A crimp base, others are B5A crimp. Is yours really a 6j1b as it's a Button base?!
The 6j1b is same as a USA 5702 (or very similar). Search Radiomuseum always with small lower case for these, i.e. 6j1B, NEVER 6J1B as they are transliterated from Cyrillic.
http://www.radiomuseum.org/tubes/tube_6j1b.html This version IS "B5A" pinch and not "Button" base
http://www.radiomuseum.org/tubes/tube_6j1b-v.html This version IS "B5A" pinch and not "Button" base
I prefer to buy the B9G Russian versions / copies of US/Europe B9G as they run at full HT. These run at lower HT and only good for mains equipment, so the small size is just an annoyance.
If the G2 is missing or very low then g1 has to be much higher for current. Likely
1) It's wired wrong
2) Not a 6j1b
ALL the special "Rod Pentodes" and most battery valves start with 1 (like USA 1.4V tubes 1T4, 1R5 etc). But not all miniature Battery tubes are "Rod" Pentodes.
This series (sub-miniature B8D style "Button" base or B5A style crimp) are really quite mediocre ordinary mains equipment valves. Just small. That's why they sell about 1 Euro each!
Anglik dyskutuje o zapisie typu po angielsku.
Zapis taki może być albo 6J1B,albo 6j1B albo 6SH1B.